Getting Paper jam in C454e With Error Code 30-03 in email and 11 on the machine.
Please find the pics and advise.
Thanks and Regards,
Getting Paper jam in C454e With Error Code 30-03 in email and 11 on the machine.
Please find the pics and advise.
Thanks and Regards,
What was done, from which tray, etc. Try to provide more information than average enduser. I'm sure you can do more.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
machine was working fine . My tech printed 200 books staple folder.
got one client to buy this printer. Bad luck my technician blowered And fully cleaned the printer since it is not working.
as mentioned earlier it was working 100% perfect
Please advise there something happened when he blowered and serviced
i have to deliver the printer tomorrow please help
thanks a lot
Have him check reg sensor, is it free moving? Arm and spring on place?
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
Also if paper makes it past fuser and jam between exit roller and fusing roller it may worth to check paper exit clutch harness or replace clutch: CL8 (p/n A161M20400)
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
Well I’d start by putting the transfer roller back in.
I added the bulletin addressing 30-03 jam in previous post. Didn't want you to miss it if you read it already.
J30-03 jams are usually caused by CL8 and/or the exit sensor (in one case both). But I would definitely install a second transfer roller. You'll want one of those. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks