A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
Tray 3 is LU-202 XL. I have read the manual and DIP switch has been changed for Registration Motor (M45) gap for hard and unspecified media.But its not working. In manual there is an adjustment for media separation but if paper jamming meets particular conditions. (A) if media goes upward and stick to intermediate transfer belt. (B) If media goes between the gap between transfer roller and fusing entrance.
In my case media jam before transfer roller. I have checked it by removing the process unit cover and cheating the switch and front door. Media reaches to registration section smoothly then suddenly it jams. Due to rotation of motor and creation of loop it moves forward a little bit and reach near Fusing exit sensor. About an inch before exit sensor.
I dont think separation adjustment will work because if it is due to separation trouble then media should also jam from Bypass tray. But from manual bypass tray same 300gm media works perfectly without a single jam. No J-3102.
I also have changed tension points of separation roller spring. Result is zero. After reading manual and doing above work i decided to take advice from KM Giants and Titans......
No... but its a useful tool. And I don't throw away a useful tool if it doesn't fit every bolt. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
We are in offtopic but just to say from my point of view, theory od operations is very good part of SM and helped me so much times to figure out strange things when just reading codes did not help directly to solve problem.
Like @tsb said,sometimes with not ordinary problems must read between lines and use logic.
What is machine counter?
Are all sizes of that 300 gsm paper jams or specific size only?
I dont understand this very well.In my case media jam before transfer roller. I have checked it by removing the process unit cover and cheating the switch and front door. Media reaches to registration section smoothly then suddenly it jams. Due to rotation of motor and creation of loop it moves forward a little bit and reach near Fusing exit sensor. About an inch before exit sensor.
How jam can be before transfer roller and near fusing exit sensor?
It should enter fusing unit to be even close to fusing exit sensor or i dont understand good?
You mean maybe near fusing loop sensor?
Did you try to change loop adjustment, it should be settings for each tray, i would try that.
Bookmarks