Paper is jamming before reaching the transport unit (feed out of the tray 1").
Tray 2 feeds fine.
New OEM rollers
New feed clutch
Adjust loop
Can't see anything wrong with guides etc
I have the manual
Any idea?
Thanks
Paper is jamming before reaching the transport unit (feed out of the tray 1").
Tray 2 feeds fine.
New OEM rollers
New feed clutch
Adjust loop
Can't see anything wrong with guides etc
I have the manual
Any idea?
Thanks
If you replaced the feed unit with one from a 363 or 223 then you are missing the additional sensor used by the 423 that would be present on the unit.
The units without the reflective sensor will have yellow wiring and 3 unused pins on the connector.
The one for the 423 will have grey or purple wiring and all the pins on the connector are in use.
Whatever
Everything he just said plus scuff the shafts and clean out the one way black bearings.
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
Two wise man spoken, this time my vote going with second
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
What is the jam code?
J-1101?
J-2002?
J-3003?
The meter count on the box?
Had it where the clutches can pull a paper coming from a lower tray but not if it needs to pull it from around a curve.
Whatever
Ive had this before and killed me. Tray 2 feeds fine, tray 1 paper stops exact same place everytime.
Fix: Remove the transfer roller unit and when you put it back in make sure the clear guide is behind the reg rollers. I never do this but I'm 100% sure this is your problem.
Bookmarks