Why does this line of codes make my hair fall out?
On the C6500 models, it was simple. Just clean the drum's potential sensor and it was resolved.
C6000 / 7000 does not have the sensor and the machine that presents the error has new drums, developers, coronas, transferbelt.
According to manual, the reasoning is:
• Printer control board
(PRCB)
• Developing unit / K
• IDC sensor (IDCS)
• IDC solenoid shutter
(SD3)
But I can guarantee that everything is in excellent condition.
biz C6000 L error code C2814
I followed the advice of lucky13 in this post above, but to no avail.
Any tips that might help?
Thanks.
Bookmarks