Thanks: 
Likes: 
Dislikes: Hi
Need help please. My Konica Minolta C2060L display "ready to print" and "controller unconnected" then, not allowing to print a all.
Any advices?
Thanks.
Konica Minolta accurio print C2060L error
Hi
Need help please. My Konica Minolta C2060L display "ready to print" and "controller unconnected" then, not allowing to print a all.
Any advices?
Thanks.
web into the controller and see whats going on.
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
Since "there is no controller" we Cannot access to the machine other than by using its own display.Originally Posted by Synthohol
through the network.
same IP you print to.
in a browser or in some cases RDC.
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
Is the controller ON and at "00"?
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
It is an onboard controller, (ic-603), when the machine is ON the controller is ON.
From what blackcat4866 said, this print controller has 2 seven segment LED displays side by side somewhere on the controller (usually found on the back of the controller or on the motherboard) that indicate its status, if it's not showing "00" after a few seconds since pressing its power button, then something is wrong with it.
I am unfamiliar with this print controller, so I can't help you locate them...
Dear sir.
Konica minolta accurio press c2060L come completely closed. You put ON the machine, the controller automatically is working. You don't even have to think about it. It's an inside part of the machine. There is no led to check no button to push... Untill I got the error "controller unconnected" or "controlleur débranché".
I think you all are thinking about some kind of fiery standing outside the machine. NO it's not like that.
I'm pretty sure it's just a matter of touching screen to reconnect it. Because all test pass and the machine is even able at this time to make copy and scanning. Only the printing, that is vitale for me, is not working because of the message "controller unconnected".
IMG_20200205_204802.jpg
Try accessing the controller following what the manuals says: Accessing PageScope Web Connection
What did you do with the device before you received the message?
Perhaps you were flashing the firmware?
also take a full screen photo.
Posting Permissions
Reply With Quote
Bookmarks