Biz i series troubleshooting guide

**copyman** · 03-22-2020

Hope this helps

**allan** · 03-22-2020

Great finally they noticed the fix for the paper feed units. Will probably get more than 150K out of the rollers.
Even it this means a different pickup, feed and separation roller.

Sure this will work on older models too.

**copier tech** · 03-23-2020

Originally Posted by copyman

Hope this helps

Thanks for sharing!

**avecosat** · 03-23-2020

Thanks for the information

**copyman** · 03-23-2020

Originally Posted by allan

Great finally they noticed the fix for the paper feed units. Will probably get more than 150K out of the rollers.
Even it this means a different pickup, feed and separation roller.

Sure this will work on older models too.

Yes, finally some good improvements. Wonder how much these new rollers are going to cost, $20 - $30 each? Lol

Speaking of rollers, I've had good results with using aftermarket from Copylite & Katun, Use the ribbed & red feed from copylite and the katun red feed for sep. The copylite red has same tacky feel as OEM the katun isn't as tacky so better for sep. Been getting at least 100k with this combination. I found if you use same red (oem or generic) for feed & sep they wear in less than 50k

**rrrohan** · 03-25-2020

i thought we always had different rollers. to be honest i only use the a00j563600 red ones but do recall back in the day use to be asked to use the blue ones for longer life.

**copyman** · 03-25-2020

Originally Posted by rrrohan

i thought we always had different rollers. to be honest i only use the a00j563600 red ones but do recall back in the day use to be asked to use the blue ones for longer life.

The 5636 rollers wear faster when used as feed and sep. Doesn't matter with pick up because not rubbing against another roller. And like I posted I have been using the ribbed for P/U instead of the red with much better results!