Hi,
I have Konica Minolta C360i. I try to upload the firmware (AA2J0Y0-F000-G00-7B-990) and I get MFP N.G. Do you have any ideas how to fix it
Hi,
I have Konica Minolta C360i. I try to upload the firmware (AA2J0Y0-F000-G00-7B-990) and I get MFP N.G. Do you have any ideas how to fix it
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
The machine hangs on the Konica Minolta inscription. I tried the latest software but it didn't help either. I cannot enter the service mode
Disconnect any installed options and select all but MFPB. If rest is updated successfully select only MFPB and try again update.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
I've done this before and it didn't work
MFPB or Storage board may be bad.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
do a data clear after backing up the address book (if any)
or
Solution
CAUSE: Corrupt MFP board or Storage board
SOLUTION: Perform the steps below.
1. Disconnect all peripherals (Finisher, Document Feeder, Fax option, etc.).
2. Load MFP Firmware only:
a. Copy folder FW0020 on the root of a recommended USB drive (refer to KBA00044472).
b. Ensure the machine is powered OFF and insert the USB drive in the front USB port.
c. Hold down the Stop button behind the little cover on the back of the Touch Panel while powering ON the machine.
b. Select MFP Controller ONLY and make sure all other firmware files are unselected.
d. Press the Start button to start loading the firmware.
e. Power OFF the machine when completed.
3. Reconnect all peripherals (Finisher, Document Feeder, Fax option, etc.)
4. Load all Firmware except MFP Controller:
a. Hold down the Stop button behind the little cover on the back of the Touch Panel while powering ON the machine.
b. Select all other firmware files and make sure MFP Controller is not selected
c. Press the Start button to start loading the firmware.
d. Power OFF the machine when completed.
5. Remove USB drive.
6. Power ON machine and test functionality.
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
I did as in the instructions above
When uploading, the counter reaches 70% and then N.G
Can you run diagnostics? If yes what it gives?
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
The machine will not allow entering the service mode
Bookmarks