Develop Ineo+ 224 Error C-2650

[mearmi]

Getting Error C-2650 in Develop Ineo+ 224

When turn on the printer it reboots 2 times and then getting error code C-2650

In Service Manual it says Main Back Up Media access error.



Trouble type C2650: Main backup media access error
Rank C
Trouble detection
condition
• The re-written data, which has been read out, checked and founded as error, is read out again and found as
error.
• The error was found when reading out the counter value.
• The main body detects that the EEPROM is not mounted.
Trouble isolation -
Relevant electrical parts • EEPROM/1
• EEPROM/2
• MFP board (MFPB)


Kindly advise.

Many Thanks

[tsbservice]

mearmi, if your Develop crosses to bizhub C224 then FWs GA8-K5 and GB8-K5 are suposed to deal among other issues with that error.
Be careful to read attached info before attempting to update FW as there are many restrictions.

[mearmi]

mearmi, if your Develop crosses to bizhub C224 then FWs GA8-K5 and GB8-K5 are suposed to deal among other issues with that error.
Be careful to read attached info before attempting to update FW as there are many restrictions.

Thanks for your message. Tried updating the firmware (M1). But getting error Invalid Memory. Tried 3 usbs with the same error.

In Initialization. After clearing all Data : Machines works for 5-10 prints then reboots with the same error code.

Please advise

Thanks

[tsbservice]

Try to update FW with front cover open.

[mearmi]

Try to update FW with front cover open.

Tried but didn’t work. Display freezes at 2 bars

waited for about 30 minutes.

Thanks

[mearmi]

mearmi, if your Develop crosses to bizhub C224 then FWs GA8-K5 and GB8-K5 are suposed to deal among other issues with that error.
Be careful to read attached info before attempting to update FW as there are many restrictions.

What do you advise?

Thanks

[Synthohol]

reseat the SSD board.

[tsbservice]

reseat the SSD board.

Agree, also reseat and clean memory DIMMs.

[mearmi]

reseat the SSD board.

Thanks a lot everyone.

Re seated SSD , Changed the RAM. Updated the firmware. And finally Changed the SSD from Non e Version. But no luck.

Still same issue.


Any advice.

Thanks once again.

[mearmi]

[QUOTE=mearmi;1483736]Thanks a lot everyone.

Re seated SSD , Changed the RAM. Updated the firmware. And finally Changed the SSD from Non e Version. But no luck.

Still same issue.


Any advice.

Thanks once again