The card stops in front of the lower electrode. Toner sensor clean. After removing the electrode the same situation. Maybe someone has ideas about what happened?
The card stops in front of the lower electrode. Toner sensor clean. After removing the electrode the same situation. Maybe someone has ideas about what happened?
Change the threads of the lower crown.
Enviado desde mi SM-J701M mediante Tapatalk
Do you mean electrode attachment?
I hope those images serve you.Screenshot_20200521-160341_Drive.jpgScreenshot_20200521-160354_Drive.jpgScreenshot_20200521-160407_Drive.jpg
Enviado desde mi SM-J701M mediante Tapatalk
Ok. I check this Tomorrow. Thx.
Wysłane z mojego EVA-L09 przy użyciu Tapatalka
I disassembled and cleaned the parts. nothing helped. I need to look for parts to replace them.
SC28-03 A separation leak is detected.
After a separation error detection
signal is detected while in the
separation ON, up to 5 separa
tion ON/OFF operations occur in
succession.The main body
stops immedi
ately to turn OFF
the main relay
(RL1).Toner control sensor board
(TCSB)
Printer control board
(PRCB)
High voltage unit /2 (HV2)
Transfer/separation charger
Power feeding contact
ADU drive board (ADUDB)
Wiring harness broken
The machine has been repaired. I replaced High voltage unit / 2 (HV2). (Part used from BZ 1050) Thanks to everyone for your help.
Bookmarks