Konica minolta "i" series freezing up.

[pickle8486]

ok so I got an i series c360i that is periodically freezing up. So far I have done all the normal steps of initializing, and running the 8 series reset tool. It is currently at 7b firmware that did load 100%. These machines seem to be a good idea, but KM needs to go back to the drawing board on the software side.

[Albonline]

ok so I got an i series c360i that is periodically freezing up. So far I have done all the normal steps of initializing, and running the 8 series reset tool. It is currently at 7b firmware that did load 100%. These machines seem to be a good idea, but KM needs to go back to the drawing board on the software side.

turn off all unneeded services/ apps. especially marketplace. may want to try putting unit into debug mode.
.

[Albonline]

have seen the emmc board, (m2 ssd ) cause erratic hard stops on this line, I have been fdisking them and recovering the copier afterward. good luck.

[copier tech]

turn off all unneeded services/ apps. especially marketplace. may want to try putting unit into debug mode.
.

Whats the best way to completely remove marketplace?

[tsbservice]

Delete this c.rap with old openAPI remove program.

[Albonline]

Whats the best way to completely remove marketplace?

there is a dip switch setting to disable it. and then turn off screensaver.

[Albonline]

Delete this c.rap with old openAPI remove program.

like this solution better , but i'm a direct employee. rules rule here.

[copier tech]

Found this post. No mention of a SW to disable it completely.


bizhub i-series hide the pre-installed MarketPlace Application

[tsbservice]

Found this post. No mention of a SW to disable it completely.


bizhub i-series hide the pre-installed MarketPlace Application

That would hide it but won't remove it. Like Albonline said or via openAPI remover.

[Albonline]

That would hide it but won't remove it. Like Albonline said or via openAPI remover.

(172 to 01) keep it under your hat!