Hi Jaco,
Just a bit of feedback regarding the error you and I had.
I did replace the PH, but with no luck. Eventually I replaced every single board in the machine still no resolution to my problem. I have used the C224 technical manual to look at a similar type of error and found that error with a bit more info regarding the error code.
It stated that there are a problem with the Temp/Humidity sensor. I have replaced the sensor, still no luck. I had a look at the circuit diagram and found that the 3.3V line to the sensor were dead.
We traced the line to the PRCB board and measured it on the board - DEAD. Eventually there were pinched wires in the Righthand door to the manual feed that caused a short and killed the 3.3V line.
Fixed the wires and the machine is running fine.
I have attached a pic for you to see.
Thanks for the help.
Regards,
Eugene
Attachment 23145
Bookmarks