Checked Kon/Min knowledge base and nothing on USA side for that code.
This procedure is exclusive to reset fuser errors.
To reset the code, perform the following:
1. Power the machine OFF with the main power switch (inside the left front door).2. Holding down the Utility key, turn the power ON. Continue to hold down the Utility key until the Konica Minolta screen is indicated.3. Press Trouble Reset.4. Press Stop-0-0-Stop-0-1 to enter the Service mode.5. Go to System 2/DIP SW settings. Confirm that switch 3-1 is set to 0.6. Cycle the power OFF/ON.
Bookmarks