The general consensus (if I can speak for the community) is to never use aftermarket toner on Konicas
I can only find switches to not show the warnings for the other consumables.
Are the other Table Number figures within spec?
Is to the PQ good on yellow?
Is the hopper full of toner?
My experience on these (which is not extensive) is that the Y TCR is always at least 1% lower than the majority of other colors. Trying to manually add in SM has not affect this state. Calibrations always got the other number in spec and prints are always fine so I just made it a habit to ignore it.
Also, I have yet to confirm this with the Cx54 series, but on the older models if you replace the toner before the purdy little illustration pops up to shake the toner (when it stops printing and actually prompts for a new toner), it will not reset the cartridge low error regardless if it the cart is full or empty.
You can probably use Synthohol's trick (good one there ). To add to this you might be able to do it with the toner out and/or just use the head (where the chip is).
Bookmarks