Hi All,
I have a few B4052's, need to disable the replace imaging unit message.
I have attempted DIPSW 51 Hex 20 and have had no luck.
Is there any other dipsw that could assist me with this issue.
Hi All,
I have a few B4052's, need to disable the replace imaging unit message.
I have attempted DIPSW 51 Hex 20 and have had no luck.
Is there any other dipsw that could assist me with this issue.
Glad to see you are not sacked like the many other of the Durban techs.
First tel me how you get those image units to run over life...
Ain't a Konica Minolta so not sure if KM kung fu will work
They are chipped and not sure if a hack exists.
Sure you will be able to get chips/programmer to get past that.
Whatever
They are chipped don't know if usual KM stuff will work. They're quite cheep and I don't think they will last longer than quoted so not much to bother.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
Would said site be Clover SA..
Whatever
once the message comes up its too late, its there until its replaced.
but before that...
[Service Mode] -> [System 2] -> [Unit Change] set warning times to "do not display"
you can also set switch 227 to 80 so it hides the consumable gauges in utility.
My bizhub 4052 imaging units often last 70% of their expected life. Rare units have lasted over 100%. Allan sure the printer stops? For now, I haven't had anyone stop by. The only problem was the quality but some customers were fine with it because they only printed text.
Bookmarks