Replaced pickup , feed and separation rollers. Cleaned sensors, pulled one way clutch off and cleaned clutch and shaft. Still jamming. Thanks
Replaced pickup , feed and separation rollers. Cleaned sensors, pulled one way clutch off and cleaned clutch and shaft. Still jamming. Thanks
For test replace oneways with another tray and gently scuf the shafts with fine emery paper if they look shiny.
Is the reg roller turn freely...could be bushings binding, disassembly and clean/replace them if worn out. Could be feed clutch also.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
You could try pulling a tray 1 CFU from another machine if you have one and swap it out. If it still jams the same way, you have just verified the issue is elsewhere.
If you don't have a tray 1 cfu to swap, if it jams feeding letter size (the wide way) but feeds a bit better changing it to Ltr-r size (the skinny way):
it will probably be a registration assembly issue or a vertical path feed issue. So disassemble inspect clean lubricate those areas. Super high clicks? Higher meter machine---suspect feed clutch.
Anything can be made to work if you fiddle with it long enough- San Diego Copier Repair.com
Jam 11-02 is typically seen when paper isn't picked up. I've seen it happen when the PE flag is broken and the tray runs out of paper. Or when the vertical guide is dislodged.
But what you really need to do is key the right side lower door and watch what happens. How far does the paper get? What obstacle does it hit? Do all the rollers turn when they should? Etc. =^..^=
Last edited by blackcat4866; 09-19-2020 at 05:51 PM.
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I feel like there is a spring loaded gear on the side of the feed unit that causes this but I do not see it in the manual. It makes you order the whole feed unit A2X0R70E11. The gear doesnt look like it does much but causes this code I think. Unless I am confused of models. Worst case just order the whole feed unit.
Bookmarks