i went through 5 black DVs because of that white bushing i posted earlier. installed new bushing and DV and problem was fixed.
it just empties out the unit, it sucked. literally! hehe
i went through 5 black DVs because of that white bushing i posted earlier. installed new bushing and DV and problem was fixed.
it just empties out the unit, it sucked. literally! hehe
Thanks much, ok I'll check for these things. Where's the bushing though?
And are all developer powder practically the same?
Gonna take me about 4-5 days to get powder here on Island. And my C75 down for repairs I have powder for that lol
Sent from my SM-G955F using Tapatalk
download the toner seal document i posted a couple pages ago in this thread.Where's the bushing though?
Hey @BillyCarpenter yep it sticks like crap to shoes lol.
So it seems as if all leaked out in there.
Sent from my SM-G955F using Tapatalk
@Synthohol thank. I'll go look for it. Appreciate the help guys.
So again another far out question would yiu guys try another developer in there. Then just replace it with the one when I get it on Island?
Sent from my SM-G955F using Tapatalk
I haven't been able to gain the information needed to help you. I saw a pic of the DV unit you pulled. But is that what the mag roller looked like right after you pulled it or did you wipe it off some? Also, did you spin the mag roller by hand to see if it would coat the mage roller and form a nice brush? If so, you can't hold the DV unit the way way it shows in your picture.
To be honest, you may be better off calling a tech to fix the problem. And, no, I wouldn't install another DV unit in the machine because it sounds like it's pulling DV to the waste toner bottle...but I'm not 100% certain about that from your answer.
I don't recommend putting another developer into machine especially from other brand. Besides your new developer unit would quickly finish in WTB if Synthohol is right(like 90%). Your best bet for short time is to take developer from WTB with help of magnet then fill up developer unit remove bushings and clean them or atleast one for black unit. You may get some results that way waiting for new bushing and K developer unit.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
Yes that's just how the DV unit looked when I pulled it out. Didn't wipe off any
When i turn the rollers, very little powder is stuck to it then nothing again.
When I checked the waste toner cartridge, by putting in a screwdriver you could see the powder stuck to it
So as pointed put could be a bushing issue.
Bookmarks