Thanks: 
Likes: +10Originally Posted by blackcat4866
Dislikes: 0
+10
I have removed all the screws belong to the part 2 but cannot take it out now I just want to know how to remove the part 1 which is just piece of plastic, no electronic involved. It does not look difficult but I can figure it out how to do it.
IMG-9779.jpg
There must be a dozen screws from the top, around the perimeter.
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
You don't think there's any electronics in the doc. feeder tray? How do you think it reads the size of the paper? I'd listen to blackcat if i were you or you may be starting another thread asking how to repair what you just broke. Just saying....
see those three slots in it? THOSE ARE SENSORS
Blackcat told you this..
just spray the tray lightly with organic cleaner.. wipe off .. go with it..
this is not rocket science man...
follow the K.I.S.S. principle
Keep It Simple Stupid.
if you remove it you are asking for major problems.
On second thought, this thread is slightly entertaining. This is a teachable moment for you. Pull that baby off.
Once bitten, twice shy.
me thinks this will explain everything :
About hquang
Country:Canada ... Where are you from (City, State):Point Roberts....Technician ....Status: End-User (Non-Tech / User)
NUFF SAID?
Agreed. This is one of those learning moments.
Some things its better to have good reason to remove. You can learn the easy way, or the hard way. Its up to you.
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
You're gonna walk him thru the repair process after he takes it off, right?
You'll want to clean it and reinstall it
Pull the shaft out, clean it. Don't lube it just clean
Blow out the rollers where shaft slides through
Clean any dried toner off rollers (if any)
Reassemble
Reinstall.
In regards to the DF don't waste time taking it apart. Nothing a paint brush, blower and some spray and wipe can't fix
Sent from my Pixel 4 XL using Tapatalk
Reply With Quote
Bookmarks