Reboot Olivetti d-Color MF282plus

[Bix]

Hi, I proceeded like this:
- Replaced SSD but keeps restarting.
- Removed options but keeps restarting.
- RAM removed: MFP stops restarting but nothing comes out on the display. Startup noise only.
- RAM replaced unsuccessfully.


At this point I am thinking of a broken MFPB. Some idea?

[emujo2]

if you think it's a 284e how many "fins" pop up before it re boots..and have you tried doing a trouble reset to get to the point where you can enter service mode to check what the error is?

[Bix]

if you think it's a 284e how many "fins" pop up before it re boots..and have you tried doing a trouble reset to get to the point where you can enter service mode to check what the error is?

The printer fails to turn on, so no errors displayed.
At this point I think PSU or motherboard defective.

[emujo2]

Your OP says re-booting..in most cases the re boot occurs after the LCD shows something..Number of fins coming up can help in troubleshooting..So you are saying you power it on and it cycles on/off at this point? E

[tsbservice]

Hi, I have a client with an Olivetti D-color 282Plus.
The printer keeps restarting every 2-3 seconds. Looks like a bizhub C284e to me. In all likelihood, the SSD no longer works. I tried to detach DF and HDD. Do you think I can insert a new Bizhub C284e SSD?

Your OP says re-booting..in most cases the re boot occurs after the LCD shows something..Number of fins coming up can help in troubleshooting..So you are saying you power it on and it cycles on/off at this point? E

2-3 seconds are not enough to see anything meaningful Ed.

[occus]

2-3 seconds are not enough to see anything meaningful Ed.

Was it possible to load a firmware after replacement? Try reseat SSD.

[CP-1015]

I have ordered a new SSDB.
I will be using the firmware of a bizhub C284e. I believe that "plus" corresponds to the "e" series.
I will let you know

Yes, it's the C284e.

[Bix]

Was it possible to load a firmware after replacement? Try reseat SSD.

Hi, the printer can only stay on for 2 seconds, so:
- Unable to log in in service mode.
- Reset tool does not have time to start.
- Failed to update firmware.


Thank you!

[occus]

07-SSD-Firmware-Ver6.05m info.pdf
TNEU1400013EN_SSD board trouble shooting 1.1[1].pdf

Bix, do you have a new SSD with green Dot? (with 6.05 already installed?)
Have a look in the troubleshooting guide.

If you can't install the firmware i think it is not possible to boot a new ssd up.
Once i forgot the firmware after replacing the ssd the device always had a bootloop.

And check your firmware in Knova. Are the generic brands, (olivetti D-Color, Develop ineo) listed in the compatibility list?

[Bix]

Hello occus, thank you for your reply.

in germany we are having logistical problems due to bad weather and the parts are arriving late. I have ordered a new SSD which is yet to arrive
For now I have taken a used SSD to make it stop rebooting. But I have seen that the solution is not effective. The printer keeps restarting anyway.
Firmware is also unknown. I wanted to try a Konica Minolta firmware because there seems to be no Olivetti firmware on Knova.