Is there any way to disable the 'replace drum unit (k)' warning message?
The printer is still printing perfectly, so was curious if the message could be disabled in system settings?
Thanks in advance!
Is there any way to disable the 'replace drum unit (k)' warning message?
The printer is still printing perfectly, so was curious if the message could be disabled in system settings?
Thanks in advance!
Konica Bizhub C220 C2 Firmware Setting
You will find what you're looking for there
Sent from my VTR-L09 using Tapatalk
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
How to apply end of life settings
1) Upgrade the FW to Version G00-C2 .
2) Make unit change setting.
Service Mode > System 2 > Unit Change > Set Service for Imaging Unit.
3) Select No Stop for each consumable.
For Imaging Unit\Drum Unit\Developing Unit.
Service Mode > Enhanced Security Mode > IU Life stop setting > set to “no stop”
For Transfer Belt and Fusing Unit
Service Mode > System 2 > Software Switch Setting.
Change Switch No: 55
Bit 2 _ ON (Transfer Belt Unit ‘no stop’)
Bit 3 _ ON (Fusing Unit ‘no stop’)
HEX should read ‘0C’ when both switches are set.
4) Eliminate Life Message Display.
Service Mode > System 2 > Software Switch Setting.
Change Switch No: 51
Bits 4,5,6,7 _ ON
HEX should read ‘F0’ when all these switches are set.
Sent from my VTR-L09 using Tapatalk
Bookmarks