C-224e: MFP Controller Download N.G.

[copier tech]

Try what emujo suggested. This is recommended procedure.

He already said he can't get into service mode.

[CP-1015]

1. Press Menu.
2. Select Counter.
3. Select Display Keypad.
4. Access Service Mode
5. Enter CE if enabled
6. Select System 2.
7. Select HDD and set to "Uninstall".
8. Select State Confirmation.
9. Select Memory/HDD Adj.
10. Press down-arrow 2/2.
11. Select SSD Format.
12. Select Logical Format.
13. Power MFP OFF/ON.
14. Repeat steps 1 through 5 to access Service Mode.
15. Select System 1.
16. Select Initialization.
17. Clear All Data.
18. Select System 2.
19. Select HDD and set to "Install".
20. Power MFP OFF/ON. \
21. Repeat steps 1 through 5 to access Service Mode.
22. Select State Confirmation.
23. Select Memory/HDD Adj.
24. Use the down-arrow to access page 2.
25. Select HDD Format.
26. Select Logical Format.
27. Power MFP OFF/ON.
28. Try firmware again.

If this fails order new SSD board. E

Thanks, I tested successfull with an other machine, where I'm able to reach service mode. But this is not booting. I'm no Minolta dealer - I can't order a SSD Board. That's the reason I would try with DLGB1401776EN. Can anybody sent me, please?

[emujo2]

He already said he can't get into service mode.

Yes, my procedure is based of the ability to enter service mode..Have you tried to get into SM using trouble reset? E

[CP-1015]

Yes, my procedure is based of the ability to enter service mode..Have you tried to get into SM using trouble reset? E

Yes, without success.

[emujo2]

There is a reset tool that might help you, it may help get the machine into a state where you can enter service mode. Someone on the site might be able to provide it to you..I think if you actually have a damaged main board or corrupt SSD this may not help either. E

[copier tech]

There is a reset tool that might help you, it may help get the machine into a state where you can enter service mode. Someone on the site might be able to provide it to you..I think if you actually have a damaged main board or corrupt SSD this may not help either. E

I would first try updating the SSD firmware to v6.03.

[Synthohol]

Ive see that happen after using the reset tool and not inputting the machine and type back in.
Make sure it's not set to ff for both.

[CP-1015]

Ive see that happen after using the reset tool and not inputting the machine and type back in.
Make sure it's not set to ff for both.

I didn't use SSD reset tool. I don't understand? What do you mean with ff?

[CP-1015]

There is a reset tool that might help you, it may help get the machine into a state where you can enter service mode. Someone on the site might be able to provide it to you..I think if you actually have a damaged main board or corrupt SSD this may not help either. E

I need firmware update for SSD Board (6.03) like copier tech wrote.

[copier tech]

I need firmware update for SSD Board (6.03) like copier tech wrote.

No, you may not need the board, V6.03 firmware may help you out.