Konica pro 1100 c-2802 low density

[Lordnixon]

So you think the IDC sensor is working ok?
Did you get the replacement IDCS?
What error do you get if you run auto gama adjust?

I'm not sure, ofс.
I'll get it in 2-3 weeks
c-2803
На датчике 2 слоя. Первый защитный можно снимать без последствий. Второй матовый слой на предположительно исправном датчике снимать не рекомендую. Вернуть в исходное состояние будет сложно.

[Lordnixon]

TCB replacement is unsuccessful.
A few days later, the TCRS was replaced. Successfully.
At the moment, more than 200k copies have been printed.

[Toxic]

Could this be your problem from start?
Nowadays OEM toner too could cause problem and make difficult to figure out what is problem with some strange errors...
Bizhub 1100_NG toner.pdf