Dislikes: 0
hello I allow myself to create a new thread because I have a problem on two pc417 modules, tray number 3 create jams on two identical copier a bizhub c450i I change the 2 modules but the two new ones do exactly the same thing I changed the paper plugs, changed the sensor, I ran out of ideas
Originally Posted by cHm
What jam code is being generated?
Where is the paper stopping?
Are there any nicks, or paper being crumpled?
cause of this is lack of or insufficient pressure on those two white rollers in the photo. The df torque limiter in this system is really tight.
JAM CODE?
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
[QUOTE = Albonline; 1718042] la cause en est un manque ou une pression insuffisante sur ces deux rouleaux blancs sur la photo. Le limiteur de couple df de ce système est vraiment serré. [/ QUOTE] hello how to fix this ?
[QUOTE = copieur addict; 1717946] Quel code de bourrage est généré?
Où s'arrête le papier?
Y a-t-il des entailles ou du papier froissé? [/ QUOTE]
hello I put a photo of the place where the paper always gets stuck
without revealing the actual jam code is like going to the dentist but wont tell them which tooth hurts.
help US to help YOU.
photos are irrelevant without the jam code.
wheres the "dentist"? lol
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
i push down on the ends of metal bracket holding the rollers. deforming enough to apply a bit more pressure. have fixed dozens of these doing only that. if you have been putting your fingers all over the feed tire system i would also clean with ipa.
Did you configure the LCT (go into Service Mode, System 2, LCT and set the paper sizes) ?
Failing to plan is planning to fail!!!
Thanks: 
Likes: 
Reply With Quote
Bookmarks