Results 1 to 4 of 4
  1. #1
    Service Manager 1,000+ Posts
    c654 and c650 finisher output tray going to the floor.


    Join Date
    Mar 2012
    Posts
    1,157
    Rep Power
    42

    c654 and c650 finisher output tray going to the floor.

    This applies to the FS608 (c650) the FS535 (for c654 ... if recall model correctly).

    So basically the sensor for the output tray paper full is being tripped prematurely and seems to be random.
    If I tap it or bang on the side of any of the finishers, the tray comes back up (after I trip the paper all over the floor).

    Anyone have a hack for this?
    I was thinking about smashing a lead fishing weight into a no so-obvious-shape and taping or gluing it onto a finger out of sight.

    It only needs to move down a blonde one to activate.

    I can take pictures if I am not being clear enough

  2. #2
    Master Of The Obvious 10,000+ Posts
    c654 and c650 finisher output tray going to the floor.

    blackcat4866's Avatar
    Join Date
    Jul 2007
    Location
    Lapeer, Michigan
    Posts
    19,471
    Rep Power
    370

    Re: c654 and c650 finisher output tray going to the floor.

    I'd like to see the photos. =^..^=
    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.
    5) You are the person onsite. Only you can make observations.

    blackcat: Master Of The Obvious =^..^=

  3. #3
    Field Supervisor 500+ Posts
    Join Date
    Mar 2017
    Posts
    985
    Rep Power
    48

    Re: c654 and c650 finisher output tray going to the floor.

    This sensor is pretty easy to get to..and a short 3 wire harness. I have seen the wires break internally, and excessive dust blocking photo interrupter, but never had this go bad. It would be very cheap just to change out the sensor and harness..If it thinks it's blocked the tray will drop down. E

  4. #4
    KonicaMinolta Senior Tech 500+ Posts srvctec's Avatar
    Join Date
    Oct 2009
    Location
    Central Kansas
    Posts
    597
    Rep Power
    49

    Re: c654 and c650 finisher output tray going to the floor.

    On finishers I have had this happen on, I just had to put a drop of Tri-Flow on the actuator pivot points since it was ever-so-slightly sticking.

    Wait a second (my CRS was on attack for a moment), I think that worked for a while but started messing up again. I eventually bent a paperclip into shape and drilled a tiny hole to accommodate it and basically used it as a weight to pull it back in home position. I think. Damn CRS.
    Started in the copier service business in the fall of 1988 and have worked at the same company since then, now the senior tech, since 2004.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here