C3070l wrinkling output paper
Hi everyone!
I own a Accuriopress C3070l and the output paper is starting to get wrinkled after we changed the fusing belt. First few copies were ok and then the next day the wrinkling occurred. I am attaching a pic bellow. The paper itself is 330x243 mm 115g.
Thank you for your help.
WhatsApp Image 2021-06-10 at 08.23.03.jpg
reduce the temperature, slightly disturb the input fusing plate!Originally Posted by daadoooo113
Στάλθηκε από το AC2003 μου χρησιμοποιώντας Tapatalk
Will try it, thanks. Could also paper that has been opened for a while cause a problem? Maybe humidity got to it?
Agreed, try lowering fusing temperature.
For years on all machines that 115g paper was nightmare to work with, especialy when output is full black or duplex.
It just wrinkle when get heat in fuser, wrap arround fusing belt,...humidity make things worse.
Now we are not using it anymore, replaced with 135g and it is much better.
When you re-assembled the fuser, and you re-installed shoulder screws ... did the shoulder seat properly into the frame? I saw one the other day, that the last tech replaced the shoulder screw with an M4 regular pan head screw. The result is the frame seats 1mm higher, in this case it was the front. And the belt walked to the rear and chewed itself up ... and wrinkled the prints. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I would recheck your installation of the belt and did you change any fuser pressure?
You said it began right after the installation.
Let us know.
Posting Permissions
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks