Thanks: 
Likes: 
Dislikes: Hi guys, I have a Bizhub 4050 that gets stuck on the bars after powering it on. The engine runs before, but the panel still shows the bars. is there any recovery tool or FW for it?
Thanks.
Hi guys, I have a Bizhub 4050 that gets stuck on the bars after powering it on. The engine runs before, but the panel still shows the bars. is there any recovery tool or FW for it?
Thanks.
Start by updating the regular firmware before you start replacing boards etc.Originally Posted by elmaligno
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
I think it's great that you try to sell your crap here, but this is a serious site and I am a technician with 30 years of experience that does not need to come with nonsense like that. This machine does not support firmware upgrade without booting, which does not happen, and that is the reason for my question.
For someone so experienced you should know about the recovery firmware!
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
I was expecting a comment like that, which shows you don't know what you are talking about, as these machines are Lexmark based and cannot be booted with firmware from the usb.
If you are so smart and you have the firmware you seem to be talking about, show it to us!
Try to unplug HDD and see it will get past boot screen and error out.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
Thanks a lot, but as I said, I did that and disconnected fax too.
Is it possible to access the web interface?
no, it is not possible
In this case you might have a faulty controllerboard or nvram/ssd (in case that's a discrete part on this crap lexmark board).
I couldn't see any recovery tools in knova. You might be able to fix it with a parts donator, otherwise I'd probably just forward it to the sales guys before ordering any
stuff based on guessworks. I sure guess the prices for these "Bizmark" PCBs are probably ridiculously high.
Reply With Quote
Bookmarks