Can the MFX C2280 Muratec be changed to take Konica Minolta C224e toner? With changing firmware, board, etc ??? I just need it to accept genuine Kon-Min toner & other consumables.
Thanks in advance
Can the MFX C2280 Muratec be changed to take Konica Minolta C224e toner? With changing firmware, board, etc ??? I just need it to accept genuine Kon-Min toner & other consumables.
Thanks in advance
Muratec documentation is a total shit show. This should help:
Failing to plan is planning to fail!!!
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
The caps on both the drum units and toners are different than the KM version. I usually keep some empties from the Muratec on both to swap over to the KM so I don't need to stock both supplies
On the new I series the machines are identical as the KM just a Muratec label on the front
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
I never really looked close but maybe there is a way to swap out the face plates for the toner & drum units from a KM to the Muratec?
Thanks for the replies.
I have a C224 parts machine I may just swap out the toner cover so the C224 toners will fit without cutting anything. And put a label on machine near toners saying to use K/M toner only!
I rebuild the drums and believe the chips are universal so should be ok with that. I would think the drums are interchangeable but never know when a supply has a chip.
Take care
Had a chance to look at a C224 toner assembly from parts machine, looks like after removing complete toner hopper assembly there are 2 screws to take toner holder off of top. This is piece that has tabs inside stopping other OEM toner to be used. Since the toner assembly comes out so easy will swap out instead of cutting tabs, etc.
Thanks again for the help.
just break the little fin off the toner to make it fit. Takes 5 seconds. I have done it several times
Ok, so I swapped out the toner holder so the Muratec will now accept K/M toners. It's going to a customer with 5 other C224e's and wants to use all Kon/MinTN321 toners.
Few other questions:
Can I use Kon/Min Firmware to update the Muratec?
Is there a way to have machine show Kon/Min instead of Muratec on web page, etc. NOT trying to deceive anyone! Trying to avoid confusion for the IT people at one of my biggest accounts!
It already printed with Kon/Min driver on my server so nothing special there.
Thanks for any help.
Bookmarks