Jam code 3003 ...1 or 2 copies out jams and folds entering fuser ! Replaced fuser ect
Sent from my SM-N981U using Tapatalk
Jam code 3003 ...1 or 2 copies out jams and folds entering fuser ! Replaced fuser ect
Sent from my SM-N981U using Tapatalk
I would try new paper exit sensor, spring and flag.
Make sure registration section isn't binding.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
If the exit sensor does not work replace the clutch on fuser drive or the fuser drive assy.
That's it right there:
Exit photointerrupter or flag
Exit clutch.
I've changed a lot of both. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Fuser drive....must be a tough 2 replace ( ^^) cat
Sent from my SM-N981U using Tapatalk
Think the fuser drive is bad
Sent from my SM-N981U using Tapatalk
It's similar to the bizhub 554e ... just more things to remove from the rear. I assisted another tech changing the exit clutch a few months ago. 2 hours. =^..^=
Last edited by blackcat4866; 10-25-2021 at 02:00 AM.
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks