So I solved this situation, now I am getting a new error Code C-5109?
So I solved this situation, now I am getting a new error Code C-5109?
Code
C-5109
Classification
PF-707m, PF-711: Centering sensor abnormality
Cause
The centering sensor (PS40) of PF fails to detect the paper for more than specified time.
Measures to take when alert occurs
The main body and the option stop immediately.
Estimated abnormal parts
• PFU drive board (PFUDB)
• Centering sensor (PS40)
Correction
Note
▪ The message "Please call service" is displayed on the panel.
Solution
1. Prior confirmation
• Check that the centering sensor (PS40) is installed correctly.
2. Execute the IO Check (18-01) of the centering sensor (PS40) when A3 papers are in the center of paper path in the horizontal conveyance
section.
3. When the result of the IO Check in the step 2 is normal, PS40 is not abnormal. Go on to step 5.
For details of IO check results, refer to "Table 1: Result check."
4. Check the connector connections, CN118 of PFUDB, CN432 (relay connector), CN433 (relay connector), CN437 (relay connector), CN410
of PS40, and the wiring between PFUDB and PS40. Then, repair it when there is any abnormality.
5. Replace PS40.
6. Replace PFUDB.
Table 1: Result check
Faulty part isolation DIPSW
Result check Normal Abnormal START About 4500 65535
Deviate from "normal" significantlySTOP About 4500 65535
Deviate from "normal" significantly
Control while detached
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
significantly
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
Does it even have a centering sensor? I doubt it.
I seem to recall that the centering sensor assembly must be installed when the PF707m is used on a C6100.
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
They should have come " ... bundled with the main body." As it says right here. Did you install them?:
PF-707
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
So there isn't one. I think I know what the problem is. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks