Hello,
One bizhub 287 B/W copier displayed C5356 on warming up process.
I checked the fan on right door, no turning on, replaced a new one however no change.
The service manual said check ICP on MFPB, it's common case cause of this board?
Hello,
One bizhub 287 B/W copier displayed C5356 on warming up process.
I checked the fan on right door, no turning on, replaced a new one however no change.
The service manual said check ICP on MFPB, it's common case cause of this board?
That should be F12E. HV unit uses the same ICP also F12E.
Does the fan spin at all at any time? It will start to spin up and then check for the lock signal.
As per the manual you can check REM and LOCK signal.
Whatever
Output check code 42 multi code 2 and 3 is for full and half speed.
Whatever
Untitled.jpg
Only runs at initial operation and while printing.
Its got relay connectors so if all else fails check continuity between MFPB and fan.
Whatever
Hello
Good day
Actually, this error is quite common in the first Bizhub 227/287/367 equipment.
I recommend you change the FM2 cooling fan and check the ICP12E that is located in the MFPB, surely that ICP must be open and you will have to replace it.
Then maybe the prints come out blank in that case you will also have to check the HV and check which electronic device is damaged.
It is recommended that you have your equipment in the version of FW G00-X8 or G00-X4
Luck
Bookmarks