Hey there all. Hope all is well. I can't figure out why we are getting prints
But the text is hazy and then we are getting blue prints especially in the edges.
Please assist thanks
Sent from my SM-G780G using Tapatalk
Hey there all. Hope all is well. I can't figure out why we are getting prints
But the text is hazy and then we are getting blue prints especially in the edges.
Please assist thanks
Sent from my SM-G780G using Tapatalk
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
If you change C drum with another Y drum what is outcome?
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
Will share the life of the toners. Yep Genuine.
I'll t4y to switch the drums around thanks
Sent from my SM-G780G using Tapatalk
Any p-codes? Could be a layer issue before the PDF was created? Use Adobe to print from.
Seen this before and looks like an issue with the document itself.
Whatever
Have you cleaned the IDC sensors under the transfer belt?
blue on the edge of the sheets is notorious on this model, note that it may not be visible till much later in imperial paper size regions due to the shorter cross direction width of the sheets.
Developing roller side seals dont do a great job, particularly on the cyan dev units. Cyan toner ends up contaminating the charge section at the same end where the leak starts, and you get fading in that zone. Eventually developer abraids the drum in this area too and you get tough textured cyan marks down that side of the page.
It is very important to vacuum out the developer suction ports when replacing developing units and vacuum / replace the toner filter. Never let it clog up. I also set the cyan TCR value to -2 (optional)
When the developing unit has failed, its important to replace it with the drum together at the same time.
Bookmarks