Any one know that how to reset this codes, after go trouble shooting but not reset and trouble code still showing.
Any one know that how to reset this codes, after go trouble shooting but not reset and trouble code still showing.
They are "abort" codes
If it won't reset I would suspect a bad board in Doc feeder. If you have another machine I would swap whole doc feeder.
Since both codes show an issue with doc feeder I would disconnect & unset the the doc -feeder in service mode, then try and reset code.
Also try updating firmware or using reset tool as last resort, can't hurt.
C-FCAB code:
MFP board (MFPB)
• DSC board/1 (DSCB/1)
• DSC board/2 (DSCB/2)
• EFI relay board
(EFIRYB: VI-506)
• Dual scan image
processing board
(DSIPB)
C-FFCB Code:
MFP board (MFPB)
• DSC board/1 (DSCB/1)
• DSC board/2 (DSCB/2)
• Dual scan image
processing board
(DSIPB)
DS board JPEG watchdog timer error
bizhub 754e/654e K TROUBLESHOOTING > 4. ABORT CODE
K-
Perhaps unrelated, but I have changed a few dual scan boards and the associated cables. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Any one know the location of DSC BOARD 1 and 2 and EFIRYB , VI 506 in the machine
Please don't take this wrong but if you don't know the locations of these and don't have the service manual to review which would show the locations then you shouldn't attempt to repair the machine. If you still want to repair perhaps someone or myself will send you service manual if you request it.
I have service and part manuals and FW.SO, i cant find out cct boards location
I totaly disconnected ADF , DSIPB from the MFPB. After that made 30 ...50 few copies the machine say " internal error has occured " and shutdown the machine . after few seconds , machine get power on automatically and paper jam signal appears
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
C-FCAB displayed
Bookmarks