Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 6 of 6
  1. #1
    Senior Tech 100+ Posts
    C250 Jamming from Tray 2

    D Colour's Avatar
    Join Date
    Oct 2008
    Posts
    198
    Rep Power
    33

    C250 Jamming from Tray 2

    We have a problem with a machine where it jams from tray 2. Have tried changing the feed assy, same thing happens, works fine for about 50 pages then jams again.

    Going to try motors and the board tomorrow, but any suggestions would be most welcome.

    Thanks!
    Everything that has a beginning, has an end.....

  2. #2
    Junior Member
    Join Date
    Oct 2008
    Location
    dublin
    Posts
    7
    Rep Power
    0
    Seen this in ours, update out for cassett holder, the ones on the machine that hold the cassett closed. If you have not updated it, this could be it.

  3. #3
    Trusted Tech 50+ Posts 8050's Avatar
    Join Date
    Feb 2009
    Location
    New York
    Posts
    88
    Rep Power
    31
    You didn't mention how many copies you have on the machine.

  4. #4
    Trusted Tech 50+ Posts
    Join Date
    Dec 2008
    Posts
    50
    Rep Power
    0
    It may be the feed roller not lowering issue....
    There is a tab on the rear of the cassettes that when pushed in drops the feed rollers. Konicas mod is to stick a small piece of metal to the tab so that it drops the rollers further.

    Our mod is to use a 25mm bulldog clip

    Over the tab & then fold down the silver arms.

    Advantages, can be removed & doesn't fall off!

    Cheers

  5. #5
    FSS / SPM 100+ Posts Setright's Avatar
    Join Date
    Nov 2008
    Posts
    247
    Rep Power
    34
    Try the lower VTC photosensor, the one at the base of the transfer section door. It's hiding in that little square hole in the metal plate. The light tends to weaken with time and cause this sort of periodic problem, around 50 pages between jams sounds about right. For some reason, it's always worst from cassette 2.

  6. #6
    Service Manager 1,000+ Posts kingarthur's Avatar
    Join Date
    Feb 2008
    Posts
    1,119
    Rep Power
    55
    Quote Originally Posted by D Colour View Post
    We have a problem with a machine where it jams from tray 2. Have tried changing the feed assy, same thing happens, works fine for about 50 pages then jams again.

    Going to try motors and the board tomorrow, but any suggestions would be most welcome.

    Thanks!
    Fit the modified lever to the paper feed assy. p/no 4030301103.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here