Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: 3510 jamming

  1. #11
    Technician 250+ Posts Rudi's Avatar
    Join Date
    Jun 2007
    Rep Power
    I had one this week that jammed with every single copy from all the drawers after, cleaning the bushings, replacing the syncro clutch , swopping the sensor and reseating connectors on pwb-a ,it still jammed then i did a total clear , problem was solved.

  2. #12
    Senior Tech 100+ Posts
    Join Date
    Nov 2008
    Rep Power
    I finally got it fixed. It was weird. I first tried the transport clutch, registration sensor, A board, main drive motor. It still jammed from all trays. I went back a few days later and then it was only jamming from the 1st tray. I replaced the 2 small clutches in the feed roll take up section, same thing. then I noticed the timing was off when the print was moving around on the page from the 1st tray. I then tried the sync clutch and it worked. I am starting to think by having it unplugged for a few days cleared some electrical glitch.

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=

IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here