Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 35
Jamming at Decurl Roller on C6500
I have a problem on a C6500 (Copy Count is only 380K) that is driving me nuts. There are no problems when the machine is set to exit the paper face up, when exiting face down the paper obviously has to refeed slightly into the ADU in order to exit face down, the paper is constantly jamming at or just before the Decurl Roller.
When the fault originally appeared you could run the decurl roller motor in service mode and occasionally it would slow and stop, with a whining noise coming from the decurl motor, I replaced the motor with no effect, I then replaced the AC driver PCB (KM Bulletin) and the fault disappeared for about 500 copies. It then reappeared and the paper jams (when exiting face down) almost constantly, this time the motor and drive all check out OK.
All sensors have been tested in tech rep and check out fine, all clutches in the ADU seem to run ok in all modes.
Is this a known fault and is there a fix. Can anyone point me in the right direction.
Thanks
-
field service supervisor
100+ Posts
- Rep Power
- 37
heres what you need to try. have you replaced the decurler roller yet. there has been a couple of problems with this roller where it got deformed. if this problem is still there after that the next question witch probably should have been the first one has there been a pm done and if so did the problem start there or before then let me know
-
Technician
- Rep Power
- 34
-
Senior Tech
100+ Posts
- Rep Power
- 35
Jamming at Decurl Roller on C6500
Yes the Decurl roller has been replaced, PM (200k) done at 260K, machine worked fine after.
-
field service supervisor
100+ Posts
- Rep Power
- 37
have you made sure bearings are sitting fine. does it ever just wrinkle the paper are always jam. i guess i should of asked this before does it jam. like physically you can say shit or is there not even a single wrinkle on the paper.
-
-
field service supervisor
100+ Posts
- Rep Power
- 37
i have also seen where techs forget to put all bearings on. they leave them on the decurler and through it away. lmao. i had to jump in my dumpster to find them and pull them out
-
Trusted Tech
50+ Posts
- Rep Power
- 33
Hi guy,
What is the error code generated by the machine? when problem occured.
May be your problem is caused PS17 - PS19 just after the fixing unit. (error code 3201-02...) paper is turned at this place
PB sensor used, broken, bad adjustement.
Regards,
-
May also bee the one way bearing on the end of the decurler roller shaft
-
Senior Tech
100+ Posts
- Rep Power
- 35
Ive seen a couple of machines with similar symptoms. The exit motor goes out(A03UM111000) alot. The motor will evetually stop turning and then take out the Conv Drive Board Assembly located at the front of the ADU/Conveyance section (A03UH05004). One sympton of this problem is when you run 11X17 face down you can hear the paper hit the lower rollers near the adu entrance section, or just stop there and jam.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks