Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: SD-511 help

  1. #1
    Trusted Tech 50+ Posts
    Join Date
    Sep 2013
    Location
    Eagan, MN
    Posts
    79
    Rep Power
    22

    SD-511 help

    I have Bizhub C224e machine with an FS534 and SD511. Set code C-1115, Center-staple knife drive motor malfunction. Cleared code, went into service mode to test motor and code sets immediately. Figuring motor has failed, removed SD unit and checked all connectors and reinstalled. Upon startup, got a "door open, please close" on finisher. Opened and closed door and it set a different code.( cannot recall number as I tried to clear right away). Now, machine will not even recognise finisher being installed. Support says replace PRCB board. Did that and FS board, and SD knife motor. Still, no finisher. Checked power supply and nothing. Replaced power supply, start up, see finisher. Have to update firmware since all boards are new. upon restart, no finisher again, no power to finisher. Going crazy trying to find the problem!!! I have new power supply on order and will power up without SD unit plugged in to see if finisher will install. Has anyone run into anything like this or know some specific things I should check? No rubbed wires but, something has to be dead shorted. Any help is appreciated!

  2. #2
    Senior Tech 100+ Posts
    Join Date
    Oct 2012
    Posts
    130
    Rep Power
    25

    Re: SD-511 help

    Check all your connectors on your finisher board. Do a continuity check on the wires from the board to the machine. Make sure those wires are plugged in.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here