Solving "Licence Error" messages without access to LMS

[Max]

Hey Jotunn


I get a "invalid entry" when I press apply after inputting the the code, in between step 4 and 5. Any ideas. ( The machine is a BH421)


-Aldo

I got the same but I think I was typing Zero and not letter O in the serial number or the other way around, cant remember now. Try it both ways.
Also Pay attention to V and U can appear quite similar

[mitchl]

I got the same but I think I was typing Zero and not letter O in the serial number or the other way around, cant remember now. Try it both ways.
Also Pay attention to V and U can appear quite similar

I'm pretty sure their zero's as opposed to the letter "o" I had to take my time entering the info as the machine didnt seem to like me inputting it, but eventually got it and it worked like a charm. Great info and time saver out in the field dont have to listen to the tech whine "I have a license error what do I do" anymore.

[tulintron]

No, no, you don't need initialization codes for particular machine types - as I wrote, they are interchangeable, so you can use BH421 serial+code to initilize C353 !!!

Hello, good morning.


I have a problem with bizhub C452. I need your help.


the equipment had the MFP and PRCB plates exchanged, occurring "license management error occurred."


I read your post about the solution, however not perminte machine go into "service mode".


after a few minutes on the machine restarts.


if you can help, I will be grateful.

[Don N.]

Guys, I will tell you a secret... you can take _any_ valid pair of initialization code/serial number and use this as many times as you wish to repair _any_ machine with license management error.

You can use for example this one - from BH421:
MFP Serial Number: A0R6021006374
Initialization Code: 2VRA4-UGGA2-Z2H4K-7AVUH-F58SW-J2Z7U-QVKVK

It doesn't matter that you have a problem with C451 or C203 or C224e, just set above S/N in the machine and use above initialization code, then restart machine and set back original S/N, reboot again - license management problem will be solved.

WORKED FOR ME on a C353!!! THANKS BRO!

[copymatebs]

I got a firmware for bizhub c253 which can clear the error of license management, if guys need it please email , tq

[Hansoon]

.
Got from a wholesaler a beautiful BH-C-360 with only 30K on the clock (really!) but with a licence error etc. This did the trick

THANKS FOR SHARING!

Hans

Just made another contribution for this great site and their great people ofcourse.......

[tulintron]

Guys, I will tell you a secret... you can take _any_ valid pair of initialization code/serial number and use this as many times as you wish to repair _any_ machine with license management error.

You can use for example this one - from BH421:
MFP Serial Number: A0R6021006374
Initialization Code: 2VRA4-UGGA2-Z2H4K-7AVUH-F58SW-J2Z7U-QVKVK

It doesn't matter that you have a problem with C451 or C203 or C224e, just set above S/N in the machine and use above initialization code, then restart machine and set back original S/N, reboot again - license management problem will be solved.

Jotunn made it very clear