Just an update, the problem turned out to be the new clutch I installed (clutch #8). After speaking with Konica Minolta technical support, they recommended removing the clutch and cleaning it, as they have had some issues with some new clutches having excess grease inside.
I removed the clutch, took it apart, and cleaned the plates with "Blue Shower Maintenance Cleaner". After reassembling, I ran over 1,000 sheets through using paper passage test with alternating trays (no jams). The plates of the clutch were basically clean, the towel I cleaned it with showed a little dirt/grease. Could possibly have been a loose connection, by dissembling and reassembling I also re-seated a large number of connections. The bulletin also mentions making sure the wires leading to clutch #8 are not too tight, which probably could lead to loosening of the connection through vibration. Re-route it if necessary. This clutch is really buried, expect this fix to take 2-4 hours.
The bulletin number is KBA01201071
Here is the link to the bulletin, you must be logged in to Konica Minolta first.
Display
Bookmarks