Hi, can you please assist the following issue:
Yellow color is missing on the status after the drum unit remplacement.
Please check attached file.
Thanks
Hi, can you please assist the following issue:
Yellow color is missing on the status after the drum unit remplacement.
Please check attached file.
Thanks
Was yellow there before you replaced the drum? If it was then you need to recheck your work. Make sure everything is properly seated and plugged in.
Possibilities are yellow dev unit, yellow laser, yellow transfer roller in ITB, high voltage.
I don't remember if the 2552ci has the little white button to push in on the DV unit which moves the mag roller to the drum, there may be a spring that allows it to move to the drum. Common problem for lost single color.
also look at the drive coupler in the back it is spring loaded and may not be engaging the unit
Did you run Sims 464 and 469 after replacing the drum as per the manual? Have you tried putting the old drum back in to see if the yellow returns? When you replaced the yellow drum, was the unit fully powered down [power button on control panel then power switch, I even unplug the unit]? Unless you fully powered down the machine may not have recognized that you replaced the drum. Does the maintenance report show the serial number of the new drum? Hope this helps.
With these devs and drum units, they need to be pushed in FIRMLY to latch fully. You should hear an audible click once it’s latched.
Bookmarks