Hello . 6950 error coming. And i cant enter in service mode . 1087 1087 not working. I try all the code which is available for Kyocera. But i can't enter. Please help.
Hello . 6950 error coming. And i cant enter in service mode . 1087 1087 not working. I try all the code which is available for Kyocera. But i can't enter. Please help.
*6950 Fuser IH PWB communication error.
No response is received in 30 ms since a command is sent to IHCPU.
A checksum error is detected 10 times in succession.*
Service manual says to check your connections. Power the machine down and reseat ALL your connections. Start with the Power Source PWB, then the Feed PWD, Fuser IH PWB, and Engine PWB.
Sometimes connectors can get worked loose, and if one section of the machine can't talk to the other, it's going to code.
Good luck.....
This will be the thermal fuse on the low voltage power supply. I believe there is a bulletin, but it is certainly common here in Australia. We repair our own.
There are a couple of small transformers on the board and there is a thermofuse tucked up in the windings under the yellow wrap. Easy repair.
Bookmarks