hello I have a kyocera taskalfa 300ci when turning on the panel shows a message "WELCOME"Check the main card and clean the ram memory, I don't have the fimware
hello I have a kyocera taskalfa 300ci when turning on the panel shows a message "WELCOME"Check the main card and clean the ram memory, I don't have the fimware
I had the same problem.
Motherboard changed ,complete keypad changed ,RAM memory changed ,hard disk changed,
all without success
Maybe the firmware memory itself is defective.
we have disposed of the machine the costs are too high for further experiments
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
I tried firmware first.
Maintenance mode was also no longer possible even with an open door
all options have been separated
all without success
Try the code dimm (or simm?) on the main board
No way out without firmware!
Inside from firmware dimm, there is also startup BIOS located.
If you mount new firmware dimm, you also must upgrade to compatible versions to engine FW and MMI FW.
Did you refit the dimm to the upper slot? It`s named "Code" slot.
Don`t mix with fax dimm......(if fax installed)
144MB for FW V15.
But if still running FW V10 or less you has to run the upgrade twice.
1. Upgrade to V10
2- Upgrade to V15
This means 288MB
Not possible to send by Email.
FW only won`t help.
You also need new Dimm or well working Dimm from other Saturn system (250ci/300ci/400ci/500ci)
(If you know how to do, you can exchange the Dimm during upgrade procedure, but if you make a mistake you`ll have 2 broken Dimms)
Bookmarks