Anyone have experience with M2540 jamming in fuser. Replaced fuser. Still jamming about halfway out. A little further out sometimes. Thanks, Chris
Anyone have experience with M2540 jamming in fuser. Replaced fuser. Still jamming about halfway out. A little further out sometimes. Thanks, Chris
hmmm.
Jam codes? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Take a look to I160_2S0_0023_SB.rev.3.pdf
If no J4211, only J4219
Check Fig. 10 Paper Feed Section1/ #11/ Frame MPF/ 302RV08010
Have seen a few pieces which are broken.
I had one that would evaporate the moisture out of the paper and it would condense above the fuser and caused a similar issue...but I don't' remember the code that it was giving
Bookmarks