You can try going to the FRPO commands on the command line:
Using FRPO commands for reprogramming the firmware.
The current settings of the FRPO parameters are listed as the optional values on the service status page.
The FRPO command is sent to the printer in the following sequence:
!R! FRPO parameter, value; EXIT;
Example: Changing emulation mode to PC-PR201/65A
!R! FRPO P1, 6; EXIT;
FRPO parameters Note:
Before changing any FRPO parameters, print out a service status page, so you will know the
parametervalues before the changes are made. To return FRPO parameters to their factory default values,
send the FRPO INIT (FRPO-INITialize) command.
(!R! FRPO INIT; EXIT
Try changing Y0 to ON.
Auto error clear at an error Y0 0��OFF, 1��ON Default 0 (OFF)
Auto error clear timeout time Y1 Value in units of 5 seconds (0 to 99). 6
Bookmarks