Kyocra 3252ci line on drum

[Colin Borwick]

This is one of those cases where only you can make the observations.

Clearly something is touching the drum, and the only way to tell what is to get your eyes in the machine to see what. There are not a lot of things within touching distance of the drum. I think that I'd take a very close look at the primary transfer belt assembly.

=^..^=

I will check out once again tomorrow just seems strange ive got two machines giving same problem Ive even spoken to other Kyocera technicians they just change the paper trays to landscape short term solution.

[BillyCarpenter]

I will check out once again tomorrow just seems strange ive got two machines giving same problem Ive even spoken to other Kyocera technicians they just change the paper trays to landscape short term solution.

I don't recommend that. The aluminum core of the drum is exposed and I've seen severe electrical arcing problems when that happens.

[Luther]

The developer spacer is frozen and not turning, replace the developer and the drum

[mga]

Hi Billy managed to get that photo of drum

Are you sure you fitted a oem complete drum unit or did you rebuild?

[Colin Borwick]

The developer spacer is frozen and not turning, replace the developer and the drum

I did replace the dev tank when I replaced the drum as the dev tank was leaking.

[Colin Borwick]

Are you sure you fitted a oem complete drum unit or did you rebuild?

100℅ OEM

[mga]

I will check out once again tomorrow just seems strange ive got two machines giving same problem Ive even spoken to other Kyocera technicians they just change the paper trays to landscape short term solution.

I see a lot of these machines if you fitted oem complete new drum and dev units I can't see what else cause that problem changing paper to a4r isn't fixing problem I don't know any Kyocera engineers that would do that.

[mga]

100℅ OEM

I see if there's anything on Kyocera site in the morning good luck for now

[Phil B.]

I see a lot of these machines if you fitted oem complete new drum and dev units I can't see what else cause that problem changing paper to a4r isn't fixing problem I don't know any Kyocera engineers that would do that.

so true.. you are inviting a case for arcing to the drum.

[allan]

Post a sample print.
Don't know this Kyo is it a mono component machine.

In the photo of the drum the one band looks polished off.
Could that be a raised mag brush due to damage or contamination on the mag roller.