I attached an example of this FS 9130 print. Printed LEF It's an older machine so I wanted to double check the problem. I am Thinking the registration clutch. Appreciate any responses... THANKS !!!
Ecosys FS 9130 Printer10272020.jpg
I attached an example of this FS 9130 print. Printed LEF It's an older machine so I wanted to double check the problem. I am Thinking the registration clutch. Appreciate any responses... THANKS !!!
Ecosys FS 9130 Printer10272020.jpg
Last edited by Doug James; 10-27-2020 at 10:24 PM.
This is a FalconIII. And if that compression is ~36mm from the trailing edge, I would check to see if the transfer roller springs and bushings are intact.
If you're getting jam J40, J41, J42, J46, J81, J87 accordianned in the fuser, I'd take a closed look at the fuser exit guide (if you can get it: 302GR25371). It was very common for endusers to slam the hell out of the door, shattering the stops off the end of the exit guide mounted to the door.
You might also have seized fuser bearings. =^..^=
Last edited by blackcat4866; 10-28-2020 at 01:07 AM.
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks