TA 3500 Paper Curling in exit tray and bunching up...

[blackcat4866]

Valuable advices received. I would only add not knowing Kyo but in KonMin you can actually adjust fuser temperature helps in preventing paper curl.

The same applies to Kyocera. The fusing temperature for Alphard toner is quite low, so you've got some wiggle room. The best way to do it is not in simulation, it's to change the temp value (normal1, normal2, normal3, thick1, etc.) for Plain media type.
=^..^=

[Doug James]

The same applies to Kyocera. The fusing temperature for Alphard toner is quite low, so you've got some wiggle room. The best way to do it is not in simulation, it's to change the temp value (normal1, normal2, normal3, thick1, etc.) for Plain media type.
=^..^=

Thanks so much !!!

[Tonerkiller]

Make sure all the filters are clean.