Originally Posted by
PrintWhisperer
Some history would be helpful, but your C0150 (Engine EEPROM) system is tied to the Main PWB EEPROM and strangely enough, the Drum and can commonly occur after improper Parts Replacement.
First make sure if you replaced the Engine or Main PWB that the original EEPROM was swapped into the new board correctly.
Generally, replacement of any EEPROM holding PWB from above must replaced individually so the single item can establish it's identity in the EEPROM system.
Replacing 2 of these parts at the same time will result in EEPROM failure, so they must be replaced individually.
If more than one element has been replaced, the old item must be returned to the device with only (1) new item (and powered up) so the system can register the new item, then proceed to the next item.
If parts were replaced (Engine PWB, MAIN PWB, DRUM) recently, you need to get them back.
Otherwise it's a brick.
Bookmarks