Hi anyone ever have this fault everything colour has magenta lines covering the copy but there is no magenta in the copies
if i run a calibration the magenta is missing
if i do a one colour magenta the copy is blank apart from the magenta lines
Hi anyone ever have this fault everything colour has magenta lines covering the copy but there is no magenta in the copies
if i run a calibration the magenta is missing
if i do a one colour magenta the copy is blank apart from the magenta lines
Last edited by outdoorkatie123; 09-26-2022 at 01:46 PM.
It would be nice to see a sample. Something like this:
And it might help to know what model that you're referring to. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
SAMPLE COPIES-5.jpgSAMPLE COPIES-4.jpgSAMPLE COPIES-3.jpgSAMPLE COPIES-2.jpgSAMPLE COPIES-1.jpg
Hi here are some of the sample copies i took whilst on site
everything copied or printed in colour has magenta lines all over the page
already replace magenta drum and dev unit primary transfer belt hv board and main power supply
If your copier has a charge roller (or four), I would start with cleaning the magenta primary charge roller.
I still don't know what model copier you have. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I agree about the charge roller cleaning, clean water on a cotton cloth and clean the charge roller
BUT...YEAH!!.... sure would be nice to know what model machine you need help with
Hi guys the copier is a UTAX 3206
ive already replaced the complete drum unit which comes complete with charge roller also replaced magenta dev unit and primary transfer belt
Although all colour copies have the magenta lines there is no magenta in the actual copies
if you look at the sample calibration the magenta square is missing
thanks
hmmmmmm.... what does that convert over to in a Kyocera?
TASKALFA 2552ci
Is the little gray button staying pressed in on the developing unit?
Is the laser slit glass clean?
Less likely: perhaps the magenta primary transfer roller is not shifting correctly, maybe popped out of it's bushings?
Have you emergency stopped the machine to determine if you have a good latent image on the magenta drum? ... on the primary transfer belt? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
My guess is LSU magenta laser drive is fubar. Note existing deletion edge indicating good charge and no defect where laser does not write to.
This is why bias components had no effect. Loupe examination of defect should show some level of dot pattern.
"Being ignorant is not so much a shame, as being unwilling to learn" - Benjamin Franklin
Bookmarks