Hey guys, How do you reset a C6000 fuser error code on one of these small machines? the normal 163 Fuser reset isnt there?
Hey guys, How do you reset a C6000 fuser error code on one of these small machines? the normal 163 Fuser reset isnt there?
Did you repair or replace the fuser? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
If that's a no, that's the first place to start. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
If there is no U-sim code to reset the fuser error, you must replace the fuser. When you replace the fuser and plug the machine back in & turn on, it will reset itself.
6000 Broken fuser heater wire
During warm up, the temperature
detected by the
thermistor does not reach
100 °C/212.0 °F for 20 s.
During warm up, the temperature
detected by the
thermistor does not reach
the stable display temperature
for 40 s, after it
reaches 100 °C/212.0 °F.
Fuser unit 1. Make sure there is no paper jam.
2. Confirm that the wiring connector is firmly connected,
and if necessary, connect the connector
all the way in.
Fuser unit - Main/Engine PWB(YC23)
3. If the wiring is disconnected, short-circuited or
has a ground fault, replace the wire.
4. If the fuser heater is not turned on (broken thermostat
wire), replace the fuser unit.
THERE IS ONLY 1 SIM CODE IN THE SERVICE MANUAL FOR THE FUSER... IT IS TO MONITOR THE FUSER TEMP ONLY (sim-199). there is no fuser reset sim... simply replace the fuser
Bookmarks