The FRPO U6 setting is only for character encoding.
In a German manual it's more clearly stated: "Contry code ((Standard-) Symbolzeichensatz)" = "default character set"
I tried it anyway. Didn't make any difference.
I also tried to enable the sleep mode type by "Multi-Set" XML config file.
Everthing was set, but this setting returned the error "not supported by target".
I am missing these settings:
https://i.gyazo.com/2a39e96ff741173f...81d1ab30e8.png
"Sleep Timer" is an other timer.
Our printers shut off the heating element already after 10-15 minutes and then it takes ~30+ Sek. for the first page.
But I found an interesting other FRPO setting:
Code:
Heater ON/OFF switch Y2
0: Heater OFF at the time of "Ready"
1: Heater ON at the time of "Ready"
Bookmarks