Yes allan PCRs are charging rollers. They are hard one type not soft type like in Brother machines which I have no problems to clean with water/soft...
Anyone having success cleaning DR-316/K PCRs. Recently had one C250i with few thin lines on prints in paper feeding direction and traced the lines to...
A little metal fabrication. The pinball door had 3 coin slots which means that also had 3 seperate coin return buttons. I didn 't need those but what...
This pinball cabinet that I'm building is gonna be the death of me. I was getting close(r) to finishing and out of nowhere the gaming PC that I built...
I don't know if I've mentioned this but all the wiring and getting things working thus far has been done on a my test bench. Much better to figure it...
This is a strange problem. I have a Zero Delay Board which is plugged in to the PC via USB cable. This device is used to map a button to a key stroke...
I hear ya but I knew better. Often times a contactor will use DC input (signal) voltage to control a much higher AC output. But this one uses both an...